Reset Rip Statistics - H3C S7500E Series Command Manual

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
[Sysname] rip 1
[Sysname-rip-1] peer 202.38.165.1
2.1.15 preference
Syntax
preference [ route-policy route-policy-name ] value
undo preference [ route-policy ]
View
RIP view
Parameters
route-policy-name: Routing policy name with 1 to 19 characters.
value: Priority for RIP route, in the range of 1 to 255. The smaller the value, the higher
the priority.
Description
Use the preference command to specify the RIP route priority.
Use the undo preference route-policy command to restore the default.
By default, the priority of RIP route is 100.
You can specify a routing policy using keyword route-policy to set the specified priority
to routes matching the routing policy.
If a priority is set for matched routes in the routing policy, the priority applies to
these routes. The priority of other routes is the one set by the preference
command.
If no priority is set for matched routes in the routing policy, the priority of all routes
is the one set by the preference command.
Examples
# Set the RIP route priority to 120.
<Sysname> system-view
[Sysname] rip 1
[Sysname-rip-1] preference 120

2.1.16 reset rip statistics

Syntax
reset rip process-id statistics
Chapter 2 RIP Configuration Commands
2-16