Jumboframe Enable - H3C S7500E Series Command Manual

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Parameters
interface-type interface-number: Port type and port number.
Description
Use the interface command to enter the related port view.
Examples
# Enter Ethernet 2/0/1 port view.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1]

1.1.13 jumboframe enable

Syntax
jumboframe enable [ value ]
undo jumboframe enable
View
Ethernet port view, port group view
Parameters
value: Maximum frame length allowed on an Ethernet port. This argument ranges from
1536 to 9216 (in bytes) and defaults to 1536.
Description
Use the jumboframe enable command to enable the forwarding of jumbo frames and
set the maximum frame length allowed on an Ethernet port.
Use the undo jumboframe enable command to set the maximum frame length
allowed on an Ethernet port to 1518 bytes.
By default, the maximum frame length allowed on an Ethernet port is 1536 bytes.
You can configure in Ethernet port view or port-group view to allow jumbo frames with
specified length to pass through Ethernet ports.
Execution of this command under Ethernet port view will only apply the
configuration to the current Ethernet port.
Execution of this command under port group view will apply the configurations to
all the ports in the port group.
Chapter 1 Ethernet Port Configuration
1-15
Commands