Gvrp Registration - H3C S7500E Series Command Manual

Command Manual – VLAN
H3C S7500E Series Ethernet Switches
<Sysname> system-view
[Sysname] gvrp
GVRP is enabled globally.

4.2.7 gvrp registration

Syntax
gvrp registration { fixed | forbidden | normal }
undo gvrp registration
View
Ethernet port view, port group view
Parameters
fixed: Sets the registration type to fixed.
forbidden: Sets the registration type to forbidden.
normal: Sets the registration type to normal.
Description
Use the gvrp registration command to configure the GVRP registration type on a port
or all ports in a port group.
Use the undo gvrp registration command to restore the default.
The default GVRP registration type is normal.
Execution of the above commands in Ethernet port view will apply the configurations to
the current port only whereas under port group view will apply the configurations to all
the ports in the port group.
GVRP provides the following three registration types on a port:
Normal. Port operating in this mode can dynamically register/deregister VLANs,
and to propagate both dynamic and static VLAN information.
Fixed. Port operating in this mode cannot dynamically register/deregister VLANs
or propagate information about dynamic VLANs. However, they can propagate
information about static VLANs. A trunk port of this type allows only manually
configured VLANs to pass through even though it is configured to carry all VLANs.
Forbidden. Port operating in this mode cannot dynamically register/deregister
VLANs or propagate VLAN information except information about VLAN 1. A trunk
port of this type allows only VLAN 1 to pass through even though it is configured to
carry all VLANs.
Note that this command is only available to trunk ports.
Related commands: display garp statistics.
Chapter 4 GARP/GVRP Configuration Commands
4-10