H3C S7500E Series Command Manual page 472

Command Manual – IPv4 Routing
H3C S7500E Series Ethernet Switches
Description
Use the peer description command to configure the description information for a
peer/peer group.
Use the undo peer description command to remove the description information of a
peer/peer group.
By default, no description information is configured for a peer/peer group.
Create a peer/peer group before configuring a description for it.
Related commands: display bgp peer.
Examples
# In BGP view, configure the description information of the peer group test as ISP1.
<Sysname> system-view
[Sysname] bgp 100
[Sysname-bgp] peer test description ISP1
5.1.49 peer ebgp-max-hop
Syntax
peer { group-name | ip-address } ebgp-max-hop [ hop-count ]
undo peer { group-name | ip-address } ebgp-max-hop
View
BGP view
Parameters
group-name: Name of a peer group, a string of 1 to 47 characters.
ip-address: IP address of a peer.
hop-count: Maximum hop count, in the range 1 to 255. The default is 64.
Description
Use the peer ebgp-max-hop command to allow establishing an EBGP connection with
a peer/peer group that is on an indirectly connected network.
Use the undo peer ebgp-max-hop command to restore the default.
By default, this feature is disabled.
You can use the argument hop-count to specify the maximum route hop count of the
EBGP connection.
Chapter 5 BGP Configuration Commands
5-43