H3C S7500E Series Command Manual page 135

Command Manual – Port Correlation Configuration
H3C S7500E Series Ethernet Switches
Note:
Do not use the broadcast-suppression command along with the storm-constrain
command. Otherwise, the multicast storm suppression ratio configured may get invalid.
Examples
# Allow broadcast traffic equivalent to 20% of the total transmission capability of
Ethernet 2/0/1 to pass and suppress the excessive broadcast packets.
<Sysname> system-view
[Sysname] interface ethernet 2/0/1
[Sysname-Ethernet2/0/1] broadcast-suppression 20
# On all the ports of the manual port group named group1, allow broadcast traffic
equivalent to 20% of the total transmission capability of each port to pass and suppress
excessive broadcast packets.
<Sysname> system-view
[Sysname] port-group manual group1
[Sysname-port-group manual group1] group-member ethernet 2/0/1
[Sysname-port-group manual group1] group-member ethernet 2/0/2
[Sysname-port-group manual group1] broadcast-suppression 20
1.1.2 description
Syntax
description text
undo description
View
Ethernet port view
Parameters
text: Description of an Ethernet port, a string of 1 to 80 characters.
Description
Use the description command to configure the description of an Ethernet port.
Use the undo description command to remove the description.
By default, the description of an Ethernet port is the port name followed by the
"interface" string, Ethernet2/0/1 Interface for example.
Chapter 1 Ethernet Port Configuration
1-2
Commands