H3C S7500E Series Command Manual page 173

Command Manual – Link Aggregation
H3C S7500E Series Ethernet Switches
Description
Use the display link-aggregation summary command to display a summary for all
link aggregation groups.
You may find that information about the remote system for a manual link aggregation
group is either replaced by none or not displayed at all. This is normal because this type
of aggregation group has no knowledge of its partner.
Examples
# Display the link aggregation group summary.
<Sysname> display link-aggregation summary
Aggregation Group Type: S -- Static, M -- Manual
Loadsharing Type: Shar -- Loadsharing, NonS -- Non-Loadsharing
Actor ID: 0x8000, 0000-fcff-ff04
AL AL
ID Type
-------------------------------------------------------------------
10 M
20 S
Table 1-3 Description on the fields of the display link-aggregation summary
command
Aggregation Group Type
Loadsharing Type
Actor ID
AL ID
AL Type
Partner ID
Select Ports
Unselect Ports
Share Type
Master Port
Partner ID
none
0x8000,0000-fcff-ff01 1
Field
Chapter 1 Link Aggregation Configuration Commands
Select Unselect Share
Ports Ports Type
1 0 NonS
0 NonS
Aggregation group type.
S: static LACP aggregation
M: manual aggregation
Load sharing type
Local system ID
Link aggregation group ID
Link aggregation type
Remote system ID
Number of selected ports
Number of unselected ports
Load sharing type
Master port
1-5
Master
Port
Ethernet2/0/2
Ethernet2/0/3
Description