Ipv6 Rip Split-Horizon - Allied Telesis IE340 Series Command Reference Manual

RIP IP 6 C
NG FOR V OMMANDS
6 -
IPV RIP SPLIT HORIZON

ipv6 rip split-horizon

Overview Use this command to perform the split-horizon action on the interface. The default
is split-horizon with poisoned reverse.
Use the no variant of this command to disable this function.
Syntax ipv6 rip split-horizon [poisoned]
no ipv6 rip split-horizon
Default Split-horizon with poisoned reverse is the default.
Mode Interface Configuration for a VLAN interface.
Usage notes Use this command to avoid including routes in updates sent to the same gateway
from which they were learned. Using the split horizon command omits routes
learned from one neighbor, in updates sent to that neighbor. Using the poisoned
parameter with this command includes such routes in updates, but sets their
metrics to infinity. Thus, advertising that these routes are not reachable.
Examples To perform split-horizon with poisoned reverse on the VLAN interface vlan2, enter
the commands:
awplus#
awplus(config)#
awplus(config-router)#
awplus(config)#
awplus(config-if)#
To disable split-horizon on the VLAN interface vlan2, enter the commands:
awplus#
awplus(config)#
awplus(config-if)#
Related show running-config
Commands
C613-50631-01 Rev A
Parameter Description
split-horizon
Perform split-horizon without poisoned reverse
poisoned
Performs split-horizon with poisoned reverse.
configure terminal
router ipv6 rip
interface vlan2
configure terminal
interface vlan2
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
exit
ipv6 rip split-horizon poisoned
no ipv6 rip split-horizon
1085