Distribute-List (Rip) - Allied Telesis AT-x510-28GTX Command Reference Manual

RIP C
OMMANDS
- (RIP)
DISTRIBUTE LIST

distribute-list (RIP)

Overview Use this command to filter incoming or outgoing route updates using the
access-list or the prefix-list.
Use the no variant of this command to disable this feature.
Syntax distribute-list {<access-list> | prefix <prefix-list>} {in|out}
[<interface>]
no distribute-list {<access-list> | prefix <prefix-list>}
{in|out}
Default Disabled
Mode RIP Router Configuration
Usage Filter out incoming or outgoing route updates using access-list or prefix-list. If you
do not specify the name of the interface, the filter will be applied to all interfaces.
Examples In this example the following commands are used to apply an access list called
myfilter to filter incoming routing updates in vlan2
awplus#
awplus(config)#
awplus(config-router)#
Related access-list extended (named)
Commands
ip prefix-list
C613-50102-01 REV C
[<interface>]
Parameter Description
prefix
Filter prefixes in routing updates.
<access-list>
Specifies the IPv4 access-list number or name to use.
<prefix-list>
Specifies the name of the IPv4 prefix-list to use.
in
Filter incoming routing updates.
out
Filter outgoing routing updates.
<interface> The interface on which distribute-list applies. For instance: vlan2
configure terminal
router rip
Command Reference for x510 Series
AlliedWare Plus™ Operating System - Version 5.4.6-1.x
distribute-list prefix myfilter in vlan2
824