Distribute-List (Rip) - Allied Telesis IE340 Series Command Reference Manual

RIP C
OMMANDS
- (RIP)
DISTRIBUTE LIST

distribute-list (RIP)

Overview Use this command to filter incoming or outgoing route updates using the
access-list or the prefix-list.
Use the no variant of this command to disable this feature.
Syntax distribute-list {<access-list> | prefix <prefix-list>} {in|out}
[<interface>]
no distribute-list {<access-list> | prefix <prefix-list>}
{in|out} [<interface>]
Default Disabled
Mode RIP Router Configuration
Usage notes Filter out incoming or outgoing route updates using an access-list or a prefix-list. If
you do not specify the name of the interface, the filter will be applied to all
interfaces.
Examples To apply an ACL called 'myfilter' to filter incoming routing updates on VLAN2, use
the commands:
awplus#
awplus(config)#
awplus(config-router)#
To apply a prefix list called 'myfilter' to filter incoming routing updates on VLAN2,
use the commands:
awplus#
awplus(config)#
awplus(config-router)#
Related access-list extended (named)
commands
ip prefix-list
C613-50631-01 Rev A
Parameter Description
<access-list>
Specifies the IPv4 access-list number or name to use.
prefix
Filter prefixes in routing updates.
<prefix-list>
Specifies the name of the IPv4 prefix-list to use.
in
Filter incoming routing updates.
out
Filter outgoing routing updates.
<interface>
The interface on which the filtering applies.
configure terminal
router rip
configure terminal
router rip
Command Reference for IE340 Series
AlliedWare Plus™ Operating System - Version 5.5.3-0.x
distribute-list myfilter in vlan2
distribute-list prefix myfilter in vlan2
1031