Debounce - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

debounce

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
debounce [ seconds ]
no debounce
Command introduced in JunosE Release 9.3.0.
Enables the debounce timer and sets the time interval that the interface waits before
reporting a state change to the upper-layer protocols. The no version restores the default
behavior, disabling debounce on the interface.
seconds—Interval for which an interface must maintain a given state before the interface
reports the state change to the upper-layer protocols. Number in the range 1–5 seconds;
default value is 1 second.
Interface Configuration
Chapter 5: D Commands
475