Idle-Cut Enable - H3C S5120-SI Series Command Reference Manual

View
Local user view
Default Level
3: Manage level
Parameters
group-name: User group name, a case-insensitive string of 1 to 32 characters.
Description
Use the group command to assign a local user to a user group.
Use the undo group command to restore the default.
By default, a local user belongs to the system default user group system.
Examples
# Assign local user 111 to user group abc.
<Sysname> system-view
[Sysname] local-user 111
[Sysname-luser-111] group abc

idle-cut enable

Syntax
idle-cut enable minute [ flow ]
undo idle-cut enable
View
ISP domain view
Default Level
2: System level
Parameters
minute: Maximum idle duration allowed, in the range 1 to 120 minutes.
flow: User idle threshold, which is in the range 1 to 10240000 bytes and defaults to 10240.
Description
Use the idle-cut enable command to enable the idle cut function and set the relevant parameters. With
the idle cut function enabled for a domain, the system will log out any user in the domain whose traffic is
less than the specified user idle threshold during the maximum idle duration.
Use the undo idle-cut enable command to restore the default.
By default, the function is disabled.
Note that:
You can also set the maximum idle duration parameter on the server. In this case, if you enable the
idle cut function and set the relevant parameters on the device, the settings on the device will take
1-24