H3C S7500E Series Command Manual page 38

Command Manual – Login
H3C S7500E Series Ethernet Switches
Use the undo user privilege level command to revert to the default command level.
By default, the commands of level 3 are available to the users logging into the AUX user
interface. The commands of level 0 are available to the users logging into VTY user
interfaces.
Examples
# Configure that commands of level 0 are available to the users logging into VTY 0.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface vty 0
[Sysname-ui-vty0] user privilege level 0
# You can verify the above configuration by Telnetting to VTY 0 and displaying the
available commands, as listed in the following.
<Sysname> ?
User view commands:
cluster
language-mode
ping
quit
super
telnet
tracert
undo
Run cluster command
Specify the language environment
Ping function
Exit from current command view
Set the current user priority level
Establish one TELNET connection
Trace route function
Undo a command or set to its default status
1-30
Chapter 1 Commands for Logging into an
Ethernet Switch