Telnet Ipv; Telnet Client Source - H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches

1.1.28 telnet ipv6

Syntax
telnet ipv6 remote-system [ -i interface-type interface-number ] [ port-number ]
View
User view
Parameters
remote-system: IPv6 address or host name of the remote system. An IPv6 address can
be up to 46 characters; a host name is a string of 1 to 20 characters.
-i interface-type interface-number: Specifies the outbound interface by interface type
and interface number. The outbound interface is required when the destination address
is a local link address.
port-number: TCP port number assigned to Telnet service on the remote system, in the
range 0 to 65535 and defaults to 23.
Description
Use the telnet ipv6 command to telnet to a remote device for remote management.
You can terminate a Telnet connection by pressing <Ctrl + K>.
Examples
# Telnet to the device with IPv6 address 3001::1.
<Sysname> telnet ipv6 3001::1
Trying 3001::1 ...
Press CTRL+K to abort
Connected to 3001::1 ...
**************************************************************************
* Copyright (c) 2004-2007 Hangzhou H3C Tech. Co., Ltd. All rights reserved.*
* Without the owner's prior written consent,
* no decompiling or reverse-engineering shall be allowed.
**************************************************************************
<Sysname>

1.1.29 telnet client source

Syntax
telnet client source { ip ip-address | interface interface-type interface-number }
undo telnet client source
Chapter 1 Commands for Logging into an
1-26
Ethernet Switch
*
*