Display User-Interface - H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
Description
Use the display telnet client configuration command to display the source IP
address or source interface configured for the current device.
Example
# Display the source IP address or source interface configured for the current device.
<Sysname> display telnet client configuration
The source IP address is 1.1.1.1.

1.1.6 display user-interface

Syntax
display user-interface [ type number | number ] [ summary ]
View
Any view
Parameters
type: User interface type.
number: Absolute or relative index of the user interface. This argument can be an
absolute user interface index (if you do not provide the type argument) or a relative user
interface index (if you provide the type argument).
summary: Displays the summary information about a user interface.
Description
Use the display user-interface command to view information about the specified or all
user interfaces.
When the summary keyword is absent, the command will display the type of the user
interface, the absolute or relative number, the speed, the user privilege level, the
authentication mode and the physical location.
When the summary keyword is present, the command will display all the number and
type of user interfaces under use and without use.
Examples
# Display the information about user interface 0.
<Sysname> display user-interface 0
Idx Type
F 0 AUX 0
+ : Current user-interface is active.
Tx/Rx Modem Privi Auth
9600 - 3
1-6
Chapter 1 Commands for Logging into an
Int
N -
Ethernet Switch