Auto-Execute Command - H3C S7500E Series Command Manual

Command Manual – Login
H3C S7500E Series Ethernet Switches
related configuration. Refer to the AAA-RADIUS-HWTACACS module of this
manual for more.
If this command is executed with the command-authorization keywords
specified, authorization is performed on the TACACS server whenever you
attempt to execute a command, and the command can be executed only when you
pass the authorization. Normally, a TACACS server contains a list of the
commands available to different users.
After you specify to perform local password authentication, when a user logs in through
the Console port, a user can log into the switch even if the password is not configured
on the switch. But for a VTY user interface, a password is needed for a user to log into
the switch through it under the same condition.
By default, users logging in through the Console port are not authenticated, whereas
modem users and Telnet users are authenticated.
Caution:
For VTY user interface, if you want to set the login authentication mode to none or
password, you must first verify that the SSH protocol is not supported by the user
interface. Otherwise, your configuration will fail. Refer to
Examples
# Configure to authenticate users using the local password.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] user-interface aux 0
[Sysname-ui-aux0] authentication-mode password

1.1.3 auto-execute command

Syntax
auto-execute command text
undo auto-execute command
View
User interface view
Parameters
text: Command to be executed automatically.
Chapter 1 Commands for Logging into an
1-3
Ethernet Switch
protocol inbound.