Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual page 968

JunosE 11.3.x Command Reference Guide A to M
Mode
924
last-resort—Installs the static route in the routing table even if the specified RTR
operation is currently unreachable, provided that no other static route to the same
network prefix is available
verify bfd-liveness-detection—Installs the static route in the routing table only if the
next hop to the specified destination address is verifiable by means of BFD liveness
detection
minInterval—Minimum proposed transmit interval and required receive interval for BFD
control packets; has the same effect as configuring the minimum receive interval and
the minimum transmit interval to the same value; number in the range 100–65535
milliseconds—for ES2 4G LM only, the range is 10–65535 milliseconds; default value
is 300 milliseconds
minRecInterval—Minimum interval at which the local peer must receive BFD control
packets sent by the remote peer; number in the range 100–65535 milliseconds—for
ES2 4G LM only, the range is 10–65535 milliseconds; default value is 300 milliseconds
minTransInterval—Minimum proposed interval between BFD control packets sent by
the local peer; number in the range 100–65535 milliseconds—for ES2 4G LM only, the
range is 10–65535 milliseconds; default value is 300 milliseconds
multValue—Detection multiplier value that the remote peer router multiplies by the
local peer's negotiated transmit interval to determine the remote peer's BFD liveness
detection interval; equal to the number of BFD packets that can be missed before the
BFD session is declared down; number in the range 1–255; default value is 3
Global Configuration, VRF Configuration
Copyright © 2010, Juniper Networks, Inc.