Mpls Rsvp Profile - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

Software for e series broadband services routers command reference a to m
Table of Contents

Advertisement

mpls rsvp profile

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
In Global Configuration mode:
mpls rsvp [ interface ] profile [ profileName ]
no mpls rsvp interface profile profileName
In Interface Configuration mode:
mpls rsvp profile profileName
no mpls rsvp profile
Command introduced before JunosE Release 7.1.0.
In Global Configuration mode, creates or modifies a configuration profile for RSVP-TE.
Places the CLI in RSVP Configuration mode. If you specify a profile not previously
configured, it is created with the factory default settings. If you do not specify a profile
name, the factory default profile is assumed. The implicit default RSVP-TE profile specifies
a value of 30,000 ms (30 seconds) for the refresh period and a value of 3 for the timeout
factor.
Any change to a profile affects all interfaces that use the profile; changes are effective
the next time the interface comes up. The no version deletes the specified profile. The
no version deletes the specified profile.
In Interface Configuration mode, creates or enables RSVP-TE on the interface with the
factory default profile or the specified profile, or disables RSVP-TE on the interface. The
no version reverts to the default profile on the interface.
In both modes, if you specify a profile not previously configured, it is created with the
factory default settings. If you do not specify a profile name, the factory default profile
is assumed. The no version deletes the specified profile. The no version deletes the
specified profile.
interface—Keyword required for the no version in Global Configuration mode
profileName—Name of a profile to be created or modified (Global Configuration mode),
applied to an interface (Interface Configuration mode), or deleted (both modes); the
profile sets the values for the protocol parameters; until you modify the profile settings,
the values match those of the implicit default profile
Global Configuration, Interface Configuration
Chapter 13: M Commands
1403

Advertisement

Table of Contents
loading

This manual is also suitable for:

Junose 11.3

Table of Contents