Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
mpls ldp targeted-hello holdtime
Syntax
Release Information
Description
Options
Mode
1370
mpls ldp targeted-hello holdtime seconds
no mpls ldp targeted-hello holdtime
Command introduced in JunosE Release 8.1.0.
Configures the LDP targeted-hello hold time, the period for which a sending LSR maintains
a record of targeted hello messages from the receiving LSR without receipt of another
targeted hello message from that LSR. Each LSR peer sends the hold time in its targeted
hello messages; peers negotiate to use the minimum of the hold times proposed by the
pair of LSRs.
The hold timer is restarted whenever the LSR receives a targeted hello from the peer in
the targeted hello adjacency. The timer expires if no targeted hello is received from the
peer within the hold time. The LSR deletes the targeted hello adjacency when the timer
expires. If all targeted hello adjacencies are deleted for an LDP session, then the LSR
terminates the LDP session.
This command takes effect immediately. The no version restores the default value, 45
seconds.
seconds—Number of seconds, in the range 1–65535
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
