Mpls Explicit-Path - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

mpls explicit-path

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
{ ip | mpls } explicit-path { name name | identifier number } [ enable | disable ]
no { ip | mpls } explicit-path { name name | identifier number }
Command introduced before JunosE Release 7.1.0.
Defines an explicit path by name or ID number and also enables or disables the explicit
path. The no version deletes the explicit path.
ip—Specifies alternative keyword for compatibility with non–E Series implementations
mpls—Specifies JunosE MPLS implementation
name—Name for the explicit path; string of up to 20 characters
number—Number identifying the explicit path in the range 1–65535
enable—Reenables the explicit path that was previously disabled on the virtual router;
to prevent a partially configured explicit path from being used, do not enable it until
you have finished configuring or modifying the path
disable—Disables the explicit path that was previously enabled on the virtual router
Global Configuration
Chapter 13: M Commands
1341