Ip Vrrp Accept-Data - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ip vrrp accept-data

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] ip vrrp vrid accept-data
Command introduced before JunosE Release 7.1.0.
Enables the backup router to process packets with an IP destination address equivalent
to the virtual addresses while the backup router is in the master state. The router ignores
this attribute when the VRRP entry uses a priority of 255. You must use the default state
(disabled) to comply with RFC 3768. When disabled, the master router drops any packets
with an IP destination address equivalent to the virtual address. The no version restores
the default value, disabled.
NOTE: When using this attribute and also restricting incoming packets to
ICMP only, you must use policy filters to accept only ICMP packets with the
virtual address as the destination address.
vrid—VRID identifier; a number in the range 1–255
Interface Configuration
Chapter 10: I Commands
967