Mpls Ldp Vpls Vpls-Id - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

Software for e series broadband services routers command reference a to m
Table of Contents

Advertisement

mpls ldp vpls vpls-id

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
mpls ldp vpls vplsName vpls-id vplsId
no mpls ldp vpls vplsName vpls-id
Command introduced in JunosE Release 8.2.0.
Configures the globally unique VPLS identifier of a VPLS instance that uses LDP as the
signaling protocol. All VEs that participate in the same VPLS domain must use the same
VPLS identifier. The VPLS identifier configured for a VPLS instance must not be the same
as the PWid for Martini configurations for Ethernet layer 2 services over MPLS. The no
version deletes the VPLS identifier from the VPLS instance.
The mpls ldp vpls vpls-id command is not valid for a VPLS instance that uses BGP as
the signaling protocol. To configure a VPLS instance with BGP signaling, use the bridge
vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls site-range
commands.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
vplsId—VPLS identifier for the VPLS instance, in the range 1–4294967295
Global Configuration
Configuring LDP Signaling for VPLS in the JunosE BGP and MPLS Configuration Guide
Chapter 13: M Commands
1375

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

Junose 11.3

Table of Contents