Grace-Period - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

grace-period

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
grace-period days [ hours [ minutes [ seconds ] ] ]
no grace-period
Command introduced in JunosE Release 8.0.0.
Configures the grace period for address leases allocated from the current DHCP local
address pool. When the address lease expires, the address enters the grace period, when
the address continues to be unavailable to other clients and can only be reassigned to
the original client. This command applies only to expired releases—to optionally apply
the grace period to addresses that are explicitly released by a client, you must enable the
use-release-grace-period command. The no version restores the default, in which no
grace period is associated with the local address pool.
days—Number of days in the grace period; in the range 0–32767
hours—Number of hours in the grace period; in the range 0–23
minutes—Number of minutes in the grace period; in the range 0–59
seconds—Number of seconds in the grace period; in the range 0–59
DHCP Local Pool Configuration
Chapter 8: G Commands
665