Ipv6 Pim Rp-Candidate - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ipv6 pim rp-candidate

Syntax
Release Information
Description
Options
Mode
1092
ipv6 pim rp-candidate interfaceType interfaceSpecifier [ group-list accessListName ]
[ hold-time holdTime ] [ priority priority ] [ interval interval ]
no ipv6 pim rp-candidate interfaceType interfaceSpecifier
[ group-list accessListName ]
Command introduced before JunosE Release 7.1.0.
Defines a router as a rendezvous point (RP) router candidate. The no version stops the
router from being an RP candidate.
interfaceType—Interface type; see Interface Types and Specifiers on page 5
interfaceSpecifier—Particular interface; format varies according to interface type; see
"Interface Types and Specifiers" on page 5. The autoRP announcement messages
will contain the IP address for this interface.
accessListName—Access-list containing the set of group prefixes supported by this
C-RP. If no group-list is specified, the default value is the entire multicast address
range.
holdTime—Amount of time in the range 1–65535 seconds that the BSR keeps an RP
in its C-RP list if the BSR does not receive a C-RP advertisement message; default
value is 150 seconds
priority—Priority field value in the range 0– 255 that the C-RP sends to the BSR in C-RP
advertisement messages; default value is 192. In the RP election process, the RP with
the lower priority value is preferred.
interval—Interval in the range 1–65535 seconds at which the C-RP sends advertisement
messages to the BSR; default value is 60 seconds
Global Configuration
Copyright © 2010, Juniper Networks, Inc.