Table of Contents
Advertisement
isis circuit-type
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
isis circuit-type [ level-1 | level-1-2 | level-2-only ]
no isis circuit-type
Command introduced before JunosE Release 7.1.0.
Configures the type of adjacency desired for the specified interface. The no version resets
the circuit type to level 1 and level 2.
level-1—Establishes a level 1 adjacency if there is at least one area address in common
between this router and its neighbors
level-1-2—(default) Establishes a level 1 and 2 adjacency if the neighbor is also
configured as a level 1-2 router and there is at least one area in common. If there is no
area in common, a level 2 adjacency is established.
level-2-only—Establishes a level 2 adjacency on the circuit. If the neighboring router is
a level 1 only router, no adjacency will be established.
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1119
Advertisement
Table of Contents
