Mpls Ldp Targeted-Hello Receive List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

mpls ldp targeted-hello receive list

Syntax
Release Information
Description
Options
Mode
1372
[ no ] mpls ldp targeted-hello receive list
{ access-list accessListName | ipAddress [ ipAddress ]* }
Command introduced before JunosE Release 7.1.0.
Configures the list of peer addresses from which MPLS accepts targeted hello messages.
When you configurea receive list, hello messages are accepted only from list members.
If no list is configured, hello messages are accepted from all addresses. The no version
removes the list of peer addresses.
NOTE: This command is unnecessary if you configure the mpls ldp
targeted-hello send list command.
accessListName—String of up to 32 alphanumeric characters that identifies an access
list
ipAddress—IP address of a peer
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Global Configuration
Copyright © 2010, Juniper Networks, Inc.