L2Tp Shutdown Destination - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

l2tp shutdown destination

Syntax
Release Information
Description
Options
Mode
1182
[ no ] l2tp shutdown destination { destinationName |
[ virtual-router vrName ] ip ipAddress }
Command introduced before JunosE Release 7.1.0.
Closes all tunnels and sessions at a destination, and prevents the creation of new tunnels
and sessions at that destination. This command works in conjunction with the l2tp drain
destination command. Both commands affect the status of the administrative state of
L2TP on the destination; the l2tp shutdown destination command sets the administrative
state to disabled. The no version enables the creation of new tunnels and sessions at
that destination.
destinationName—Name the router assigns to the LNS
vrName—Name of the virtual router on which the destination exists
ipAddress—IP address of the LNS
Global Configuration
Copyright © 2010, Juniper Networks, Inc.