Ip Igmp Promiscuous - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ip igmp promiscuous

Syntax
Release Information
Description
Options
Mode
820
ip igmp promiscuous { on | off }
no ip igmp promiscuous
Command introduced before JunosE Release 7.1.0.
Enables the specified interface to accept IGMP reports from hosts on any subnet. The
no version specifies that an IGMP interface should use the Router Configuration mode
setting (see the igmp promiscuous command) to determine from which subnets it can
accept IGMP reports.
on—Enables the interface to accept IGMP reports from hosts on any subnet
off—Allows the interface to accept IGMP reports only from hosts on subnets associated
with this interface
Interface Configuration, Profile Configuration
Copyright © 2010, Juniper Networks, Inc.