Enable Ipsec-Transport - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

enable ipsec-transport

Syntax
Release Information
Description
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] enable ipsec-transport
Command introduced before JunosE Release 7.1.0.
IP Tunnel Destination Profile Configuration mode added in JunosE Release 8.2.0.
In IP Tunnel Destination Profile Configuration mode, specifies that the router accepts
only dynamic IP tunnels protected by an IPSec transport connection. The no version
disables IPSec transport mode.
In L2TP Destination Profile Host Configuration mode, specifies that the router accepts
only L2TP tunnels protected by an IPSec transport connection. The no version disables
IPSec transport mode.
IP Tunnel Destination Profile Configuration, L2TP Destination Profile Host Configuration
Chapter 6: E Commands
555