Isis Retransmit-Interval - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

isis retransmit-interval

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
isis retransmit-interval seconds
no isis retransmit-interval
Command introduced before JunosE Release 7.1.0.
Configures the number of seconds between retransmission of LSPs with the same lsp-id
for point-to-point links. The no version restores the default value.
seconds—Number of seconds in the range 1–65535; default value is 5. The number
should be greater than the expected round-trip delay between any two routers on the
attached network. The setting of this parameter should be conservative, or needless
retransmission will result. The value should be larger for serial lines.
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1131