Local Ip Identity - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

local ip identity

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
local ip identity
{ address ipAddress | range ipRangeLow ipRangeHigh | subnet netAddress netMask }
no local ip identity
Command introduced in JunosE Release 7.3.0.
Overrides the local identity (phase 2 identity) used for IPSec security association
negotiations. For IPSec negotiations to succeed, the local and peer identities at one end
of the tunnel must match the peer and local identities at the other end (respectively).
The no version restores the default value, wildcard network value 0.0.0.0/0.
ipAddress—IP address used as the local identity for IPSec security association
negotiations
ipRangeLow—Low end of a range used as the local identity for IPSec security association
negotiations
ipRangeHigh—High end of a range used as the local identity for IPSec security
association negotiations
netAddress—IP network address used as the local identity for IPSec security association
negotiations
netMask—IP network mask used as the local identity for IPSec security association
negotiations
IPSec Tunnel Profile Configuration
Chapter 12: L Commands
1231