Table of Contents
Advertisement
convergence-factor
Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
convergence-factor convergenceFactor
no convergence-factor
Command introduced in JunosE Release 8.0.0.
Specifies the convergence factor for all simple shared shapers on the router. The
convergence factor determines how quickly the dynamic shaping rate converges with
the calculated dynamic shaping rate, and is expressed as a percentage of the available
bandwidth. The no version removes the specified convergence factor from all simple
shared shapers on the router.
convergenceFactor—Percentage value in the range 0–99; default value is 50
QoS Shared Shaper Control Configuration
Configuring Simple Shared Shaper Algorithm Variables
Chapter 4: C Commands
459
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 and is the answer not in the manual?
Questions and answers