Mpls Ldp Session Holdtime - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

mpls ldp session holdtime

Syntax
Release Information
Description
Options
Mode
1364
mpls ldp session holdtime holdTime
no mpls ldp session holdtime
Command introduced before JunosE Release 7.1.0.
Configures the LDP session hold time, the period that an LSR maintains a session without
receipt of a message from an LDP peer. Each LSR peer sends the session hold time in its
initialization message; peers negotiate to use the minimum of the session hold times
proposed by the pair of LSRs. This negotiated session hold time is used by the keepalive
timer to maintain the session.
The keepalive timer is reset with the receipt of any session message from the peer. In the
absence of other LDP protocol messages are being sent, peers periodically send a
keepalive message to maintain the LDP session.
The LDP session is terminated when the timer expires. The no version restores the default
value, 180.
holdTime—Number of seconds in the range 15–65535
Global Configuration
Copyright © 2010, Juniper Networks, Inc.