L2Tp Shutdown Tunnel - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

l2tp shutdown tunnel

Syntax
Release Information
Description
Options
Mode
1184
[ no ] l2tp shutdown tunnel { destinationName |
[ virtual-router vrName ] ip ipAddress tunnelName }
Command introduced before JunosE Release 7.1.0.
Closes all sessions in a tunnel, and prevents the creation of new sessions in that tunnel.
This command works in conjunction with the l2tp drain tunnel command. Both commands
affect the status of the administrative state of L2TP on the tunnel; the l2tp shutdown
tunnel command sets the administrative state to disabled. The no version enables the
creation of new sessions in that tunnel.
destinationName—Name the router assigns to the LNS
vrName—Name of the virtual router on which the tunnel exists
ipAddress—IP address of the LNS
tunnelName—Name of the tunnel
Global Configuration
Copyright © 2010, Juniper Networks, Inc.