Loopback - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

loopback

Syntax
Release Information
Description
Copyright © 2010, Juniper Networks, Inc.
For module controllers, the options available vary depending on the module being
configured.
CT3 module:
loopback { local | network | payload }
no loopback
[ no ] loopback remote
cOCx/STMx SONET controller (SONET/SDH section layer), OCx/STMx line modules:
loopback { local | network }
no loopback
COCX-F3 module:
loopback { local | network | payload }
no loopback
For interfaces; the options available vary depending on the interface being configured.
ATM interface (cannot be used on a subinterface):
loopback { diagnostic | line }
no loopback
POS interface:
[ no ] loopback { internal | line }
Command introduced before JunosE Release 7.1.0.
Specifies the loopback mode for a module controller or interface. The no version clears
all loopback on the module or interface (the default), or deletes the mapping to the user
domain name.
NOTE: In Domain Map Configuration mode, this command has been replaced
by the local-interface command and may be removed completely from
Domain Map Configuration mode in a future release.
Chapter 12: L Commands
1249