Ipv6 Ospf Priority - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ipv6 ospf priority

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ipv6 ospf [ processId ] priority intfPriority
no ipv6 ospf [ processId ] priority
Command introduced before JunosE Release 7.1.0.
Sets the router priority. Used in determining the designated router for the particular
network. This designation applies only to multiaccess networks. Every broadcast and
nonbroadcast multiaccess network has a designated router. The no version restores the
default value.
processId—Integer in the range 1–65535
intfPriority—Priority value, an 8-bit number in the range 1–255; default value is 1
Interface Configuration, Subinterface Configuration
Chapter 10: I Commands
1081