Ip Vrrp Icr-Partition Vlan-Range - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ip vrrp icr-partition vlan-range

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
ip vrrp vrid icr-partition vlan-range [ vlanIdStart vlanIdEnd ]
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition vlan-range [ vlanIdStart vlanIdEnd ]
Command introduced in JunosE Release 10.3.0.
Adds a range of VLANs to the ICR partition. You can assign only unique VLANs to the
partition. If you attempt to assign a previously assigned VLAN range to the ICR partition,
the router displays an error message. You can assign VLANs only if you have selected
VLAN based grouping by using the ip vrrp icr-partition group command. The no version
deletes the VLAN range from the ICR partition.
NOTE: You can use the listed optional parameters only when you add a VLAN
or a range of VLANs to the ICR partition. You cannot modify an existing
subinterface using these parameters. You can specify the optional parameters
in any order.
vrid—VRID identifier; a number in the range 1–255
vlanIdStart—Starting VLAN ID of the VLAN subrange you are configuring; a number in
the range 0–4095
vlanIdEnd—Ending VLAN ID of the VLAN subrange you are configuring; a number in the
range 0–4095
use-default-mac—Configures the VLAN range to use the default MAC address. By
default, the router assigns the VRRP MAC address to all subinterfaces of the ICR
partition.
control-interface—Controls traffic on a range of subinterfaces that are part of a backup
partition. When you use this option, the router changes the state of the corresponding
range of subinterfaces to Admindown. When the subinterfaces are in Admindown
state, the router blocks all traffic to the interfaces. However, the router does not block
advertisements as long as VRRP is running on a separate subinterface. The router
changes the state of the range of subinterfaces from Admindown to Up when the state
of the partition changes from backup partition to master.
advertise-mac—Enables subinterfaces to transmit GARP advertisments when the
partition moves from backup state to master state. By default, GARP advertisements
are blocked on subinterfaces.
Interface Configuration, Subinterface Configuration
Grouping ICR Subscribers Based on VLAN IDs
Chapter 10: I Commands
979