Minimum-Dynamic-Rate-Percent - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

minimum-dynamic-rate-percent

Syntax
Release Information
Description
Options
Mode
Related
Documentation
Copyright © 2010, Juniper Networks, Inc.
minimum-dynamic-rate-percent minimumDynamicRatePercent
no minimum-dynamic-rate-percent
Command introduced in JunosE Release 8.0.0.
Specifies the minimum value of the dynamic shaping rate as a percentage of the shared
shaping rate for all simple shared shapers on the router. The no version removes the
specified minimum dynamic rate from all simple shared shapers on the router.
minimumDynamicRatePercent—Minimum percentage value of the dynamic shared
shaper in the range 0–100; default value is 0
QoS Shared Shaper Control Configuration
Configuring Simple Shared Shaper Algorithm Variables
Chapter 13: M Commands
1313