Interface Gigabitethernet - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

interface gigabitEthernet

Syntax
Release Information
Description
Options
Mode
Related
Documentation
716
[ no ] interface gigabitEthernet interfaceSpecifier
Command introduced before JunosE Release 7.1.0.
Specifies or creates a Gigabit Ethernet interface or a subinterface over a Gigabit Ethernet
interface. The no version removes the interface or subinterface.
NOTE: On the GE I/O module, you can configure only the primary port, 0. The
router automatically uses the redundant port, 0R, if the primary port fails.
On the GE-2 APS I/O module, you can configure only the primary ports, 0 and
1. The router automatically uses the corresponding redundant port, 0R or 1R,
if the primary port fails.
On the OC3-2 GE APS I/O module, you can configure only a Gigabit Ethernet
interface in port 2. Ports 0 and 1 are reserved for OC3/STM1 ATM interfaces.
On the ES-2 GE-4 IOA, you can configure all four ports.
interfaceSpecifier—Particular interface; format varies according to interface type; see
Interface Types and Specifiers on page 5
Global Configuration
Configuring the QoS Shaping Mode for Ethernet Interfaces
Creating a QoS Interface Hierarchy for Bulk-Configured VLAN Subinterfaces with
RADIUS
Configuring a Parameter Definition to Shape Ethernet Traffic Using Cell Mode
Copyright © 2010, Juniper Networks, Inc.