Ipv6 Ospf Hello-Interval - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ipv6 ospf hello-interval

Syntax
Release Information
Description
Options
Mode
1078
ipv6 ospf [ processId ] hello-interval helloInterval
no ipv6 ospf [ processId ] hello-interval
Command introduced before JunosE Release 7.1.0.
Specifies the interval between hello packets that the router sends on the interface. The
no version resets the hello interval to its default.
processId—Integer in the range 1–65535
helloInterval—Number in the range 1–65535 seconds; default value is 10 seconds
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.