JunosE 11.3.x Command Reference Guide A to M
Mode
Related
Documentation
1390
NOTE: The relay-format keyword determines the pseudowire PW Type value
that is used in LDP protocol messages. For a complete list of pseudowire
Type values, see http://www.iana.org/assignments/pwe3-parameters.
If you do not specify the relay-format keyword in the mpls-relay or route
interface command, the pseudowire Type value is chosen based on the type
of the interface. For Ethernet interfaces, the pseudowire Type value is chosen
as Ethernet (0x0005). For VLAN interfaces, the pseudowire Type value is
chosen as Ethernet Tagged Mode (0x0004)
Interface Configuration, Subinterface Configuration
Configuring an MPLS Pseudowire with VCC Cell Relay, Configuring Ethernet/VLAN Layer
2 Services, Configuring Frame Relay Layer 2 Services, Configuring HDLC Layer 2 Services,
Configuring Local ATM Cross-Connects Between Ethernet/VLAN Interfaces, Configuring
Ethernet Raw Mode Encapsulation for Martini Layer 2 Transport, and Configuring S-VLAN
Tunnels for Layer 2 Services in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.