Exclude-Prefix - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

exclude-prefix

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
[ no ] exclude-prefix Ipv6Prefix [ endIpv6prefix ]
Command introduced in JunosE Release 10.1.0.
Specifies the IPv6 prefix or range of prefixes to exclude from being allocated to the
requesting router. You can exclude those prefixes that have been assigned to local
interfaces from being delegated to the DHCPv6 clients. The no version removes the IPv6
prefix or prefix range from the exclusion set and makes it available again for delegation
to clients.
NOTE: If you attempt to exclude a prefix range that overlaps with another
prefix range that has been already excluded from delegation to clients in the
IPv6 local address pool, an error message is displayed and the configuration
fails.
Ipv6Prefix—IPv6 prefix or the starting IPv6 prefix of the range of prefixes to be excluded
from being delegated to the requesting router.
endIpv6Prefix—Ending prefix of the range of IPv6 prefixes to be excluded from being
delegated to the requesting router. If you specify this value, all prefixes from the starting
IPv6 prefix up to this prefix are excluded from allocation.
IPv6 Local Pool Configuration
Chapter 6: E Commands
605