Table of Contents
Advertisement
maximum-paths
Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
For BGP:
maximum-paths [ ibgp | eibgp ] maxPaths
no maximum-paths [ ibgp | eibgp ] [ maxPaths ]
For IS-IS and RIP:
maximum-paths maxPaths
no maximum-paths
For OSPF:
maximum-paths maxPaths
no maximum-paths maxPaths
Command introduced before JunosE Release 7.1.0.
Controls the maximum number of equal-cost paths to the same destination that BGP,
IS-IS, OSPF, or RIP can install in the routing table to support ECMP.
For BGP and RIP, issue the command from Router Configuration mode to apply the value
to routes in the global RIB. In Address Family Configuration mode, issue the command
only in the context of IPv4 unicast and IPv6 unicast address families to apply the value
only to routes in the global RIB or the specific VRF for the IPv4 unicast or IPv6 unicast
address family; This command is not supported for VPNv4 or VPNv6 address families.
For IS-IS or OSPF, issue the command from Router Configuration mode.
The no version restores the default value, 1 path for BGP or 4 paths for IS-IS, OSPF, and
RIP.
ibgp—Specifies that the maxPaths value applies only to routes received from internal
(IBGP) peers; if no keyword is specified, the maxPaths value applies only to routes
received from external (EBGP) peers
eibgp—Specifies that the maxPaths value applies to routes received from IBGP and
EBGP peers; can be used only for VRF IPv4 unicast and IPv6 unicast address families
maxPaths—Maximum number of parallel paths (routes) in the range 1–16
Address Family Configuration, Router Configuration
Chapter 13: M Commands
1289
Advertisement
Table of Contents
