Match Ip Address - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

match ip address

Syntax
Release Information
Description
Options
Mode
1274
match ip address { accessListName [ accessListName ]* |
prefix-list prefixListName [ prefixListName ]* | prefix-tree treeName [ treeName ]* }
no match ip address [ accessListName ]* | prefix-list [ prefixListName ]* |
prefix-tree [ treeName ]*
Command introduced before JunosE Release 7.1.0.
Matches any routes that have a destination network number address that is permitted
by a standard or extended access list, a prefix list, or a prefix tree, or performs policy
routing on packets. You cannot mix references in the same match command; you can
only specify either access list(s), prefix list(s), or prefix tree(s). The no version removes
the match clause from a route map unless you specify a value, in which case only that
value is removed from the match clause.
accessListName—String of up to 32 alphanumeric characters
prefixListName—Name of a single prefix list; string of up to 32 characters
treeName—Name of a single prefix tree; string of up to 32 characters
*—Indicates that one or more parameters can be repeated multiple times in a list in
the command line
Policy List Configuration, Route Map Configuration
Copyright © 2010, Juniper Networks, Inc.