Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
log severity
Syntax
Release Information
Description
Options
1242
log severity { severityValue | off | severityNumber }
[ eventCategory [ instanceTree ] | eventCategory instanceTree | eventCategory ]
no log severity [ severityValue | off | severityNumber ] [ eventCategory
[ filters | instanceTree ] | eventCategory { filters | instanceTree } | eventCategory | * ]
Command introduced before JunosE Release 7.1.0.
Sets the severity level for systemwide logs (that is, when no individual event category is
specified) or for a specific event category. The no version returns severity changes to
their default settings or the systemwide setting.
NOTE: After you change the log severity level for an individual log event
category, you cannot use systemwide commands to subsequently change
the severity level for that category. To change individually altered log event
categories using systemwide commands, you must first change the log event
back to its default setting.
severityValue and severityNumber—Minimum severity of the log messages displayed
for the selected category; described either by a descriptive term—severityValue—or by
a corresponding number—severityNumber—in the range 0–7. The lower the number,
the higher the priority:
emergency or 0—System unusable
alert or 1—Immediate action needed
critical or 2—Critical condition exists
error or 3—Error condition
warning or 4—Warning condition
notice or 5—Normal but significant condition
info or 6—Informational message
debug or 7—Debug message
off—Disables systemwide log severity for all default level event categories when no
event category is specified or disables log severity for a specified event category
eventCategory—Log category; refer to the CLI online Help for available options
filters—Removes all log filters for the event category
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
