Maximum Routes - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

maximum routes

Syntax
Release Information
Description
Options
Mode
1290
maximum routes limit { warningThreshold | warning-only }
no maximum routes
Command introduced before JunosE Release 7.1.0.
Sets a warning threshold and maximum limit for routes imported by a PE router into a
VRF from associated CE routers. The no version removes the limit and warning threshold.
limit—Number in the range 1–4294967295 that when exceeded prevents routes from
being imported into the routing table; when first exceeded generates a limit-exceeded
log entry; if the route count fluctuates below and up to this value, an interval of five
minutes must pass before another limit-exceeded log entry can be generated
warningThreshold—Percentage in the range 1–100 that when first exceeded generates
a warning-threshold-exceeded log entry; if the route count fluctuates around this value,
an interval of five minutes must pass before another warning-threshold-exceeded log
entry can be generated
warning-only—Causes the limit to function as a warningThreshold; specifies that
exceeding the limit generates a warning-threshold-exceeded log entry instead of a
limit-exceeded log entry and permits routes exceeding the limit to be added to the
routing table; if the route count fluctuates around the limit, an interval of five minutes
must pass before another warning-threshold-exceeded log entry can be generated
VRF Configuration
Copyright © 2010, Juniper Networks, Inc.