Ipv6 Access-List - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ipv6 access-list

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
Extended IPv6 access list:
ipv6 access-list accessListName { permit | deny } { srcIPv6Prefix |
host srcIPHost | any } { dstIPv6Prefix | host dstIPHost | any } [ log ]
no ipv6 access-list accessListName [ { permit | deny } { srcIPv6Prefix |
host srcIPv6Host | any } { dstIPv6Prefix | host dstIPv6Host | any } [ log ] ]
Command introduced before JunosE Release 7.1.0.
Defines an IPv6 access list. The extended access list enables you to specify a destination
address or host, precedence, and type of service. Imposes an implicit last rule of " deny
ip any any" to deny all routes that do not match previous rules in the access list. The no
version removes the IPv6 access list, the specified entry in an access list, or the log for a
specified entry.
accessListName—String of up to 32 alphanumeric characters
permit—Permits access if the conditions are matched
deny—Denies access if the conditions are matched
srcIPv6Prefix—Source IPv6 address and mask length from which the packet is being
sent
srcIPv6Host—Source host IPv6 address; assumes a mask length of 128
any—Creates an address of :: with a mask length of 0
dstIPv6Prefix—Destination IP address and mask length
dstIPv6Host—Destination host IPv6 address to which the packet is being sent
log—Logs an Info event into the ipAccessList log whenever the access-list rule is
matched
Global Configuration
Chapter 10: I Commands
1009