Mpls Ldp Vpls Neighbor - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

mpls ldp vpls neighbor

Syntax
Release Information
Description
Options
Mode
Related
Documentation
1374
[ no ] mpls ldp vpls vplsName neighbor ipAddress
Command introduced in JunosE Release 8.2.0.
Configures the remote VPLS edge (VE) device address of a neighbor in the VPLS domain
in which the VPLS instance participates. The specified VPLS instance must use LDP as
the signaling protocol. If either or both LDP or MPLS are not configured on the current
virtual router, issuing this command creates the LDP and MPLS configurations
automatically. The no version deletes the neighbor from the VPLS domain.
The mpls ldp vpls neighbor command is not valid for a VPLS instance that uses BGP as
the signaling protocol. To configure a VPLS instance with BGP signaling, use the bridge
vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls site-range
commands.
vplsName—Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
ipAddress—IP address of a neighbor in the VPLS domain
Global Configuration
Configuring LDP Signaling for VPLS in the JunosE BGP and MPLS Configuration Guide
Copyright © 2010, Juniper Networks, Inc.