Table of Contents
Advertisement
JunosE 11.3.x Command Reference Guide A to M
max-interfaces
Syntax
Release Information
Description
Options
Mode
1292
For Tunnel Server Configuration mode:
max-interfaces { maxInterfacesValue | all-available }
no max-interfaces
For IPSec Tunnel Profile Configuration mode:
max-interfaces maxInterfacesValue
no max-interfaces
Command introduced before JunosE Release 7.1.0.
IPSec Tunnel Profile Configuration mode added in JunosE Release 7.3.0.
For Tunnel Server Configuration mode, provisions the maximum number of tunnel-service
interfaces to be used on a tunnel-server port. The default version restores the default
configuration. On dedicated tunnel-server ports, the default configuration is all-available
(the maximum number of tunnel-service interfaces that the tunnel-service module
supports). On shared tunnel-server ports, the default configuration is zero tunnel-service
interfaces provisioned. The no version unprovisions the tunnel-server port by reducing
the number of provisioned tunnel-service interfaces to zero.
For IPSec Tunnel Profile Configuration mode, defines the maximum number of interfaces
that the IPSec tunnel profile can instantiate. The no version returns the maximum value
to zero (0) to indicate no limit to the number of interfaces that can be instantiated on
this profile.
maxInterfacesValue—For Tunnel Server configuration, the maximum number of
tunnel-service interfaces that can be provisioned on a tunnel-server port in the range
0–16000; For IPSec Tunnel Profile configuration, the maximum number of interfaces
that the IPSec tunnel profile can instantiate in the range 0–32767
all-available—Specifies that the maximum number of tunnel-service interfaces that
can be provisioned on a tunnel-server port matches the maximum number supported
by the tunnel-server module
IPSec Tunnel Profile Configuration, Tunnel Server Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
