Ip Address - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

ip address

Syntax
Release Information
Description
Options
Mode
Related
Documentation
732
ip address ipAddress ipMask [ secondary ]
no ip address [ ipAddress ipMask [ secondary ] ]
Command introduced before JunosE Release 7.1.0.
Sets a primary or secondary IP address for an interface or subinterface. The no version
removes an IP address or disables IP processing. You must specify the layer 2
encapsulation before you can set the IP address.
ipAddress—IP address in 32-bit dotted decimal format (for example, 192.56.32.2)
ipMask—mask for associated IP subnet in dotted decimal or prefix length notation
secondary—Specifies that the configured address is a secondary IP address; if omitted,
the configured address is the primary IP address
Interface Configuration, Profile Configuration, Subinterface Configuration
Configuring Local ATM Cross-Connects with AAL5 Encapsulation, Configuring Local
Cross-Connects Between Ethernet/VLAN Interfaces, Configuring the Loopback Interface
and Router ID for BGP for L2VPNs, Configuring the Loopback Interface and Router ID for
VPLS, and Configuring MPLS LSPs for L2VPNs in the JunosE BGP and MPLS Configuration
Guide
Copyright © 2010, Juniper Networks, Inc.