Mpls Create-Dynamic-Interfaces - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

JunosE 11.3.x Command Reference Guide A to M

mpls create-dynamic-interfaces

Syntax
Release Information
Description
Options
Mode
1338
mpls create-dynamic-interfaces
{ ip | ipv6 } on-major-interfaces [ for-vpn-traffic ] [ profile profileName ]
no mpls create-dynamic-interfaces
{ ip | ipv6 } on-major-interfaces [ for-vpn-traffic ]
Command introduced in JunosE Release 7.1.0.
Specifies whether dynamic IP interfaces are automatically created on top of all MPLS
major interfaces, and if so, which profile is used to create them. By default, one IPv4
dynamic interface without a profile is created and used for both VPN and non-VPN traffic.
If IPv6 is enabled on the virtual router, then by default, one IPv6 dynamic interface without
a profile is created and used for both VPN and non-VPN traffic. The no version restores
the default behavior.
ip—Specifies that the created dynamic interfaces are IPv4
ipv6—Specifies that the created dynamic interfaces are IPv6
for-vpn-traffic—Specifies that the created dynamic interface is used for BGP/MPLS
VPN traffic; VPN traffic uses the same IP interface as non-VPN traffic if separate IP
interfaces are not created for the VPN traffic
profileName—Name of a profile that sets the values that configure the IP interface; if
you do not specify a profile, the interface attributes are set to their default values
Global Configuration
Copyright © 2010, Juniper Networks, Inc.